Devolo dLAN 200 AVpro Wireless N Manuel de service télécharger pdf (Page 34)

Network configuration 33

devolo dLAN 200 AVpro Wireless N

Configuration over the web

The option The device can be configured over the

web has to be enabled in order for the configuration

interface to be accessible at all.

Disabling this option rules out the

possibility of configuring and thus

accessing the interface. This status

can be reversed only by resetting

the adapter to the factory defaults

(see the Reset section).

4.4.2 Network settings

The dLAN 200 AVpro Wireless N also communicates

via the TCP/IP protocol as a component of your home

network. The IP address required for this can either be

entered manually as a static address or obtained auto-

matically from a DHCP server.

The option Use this to accept network settings

automatically from a DHCP server is enabled in

the factory defaults.

If a DHCP server is already present in the network for

giving out IP addresses, have the option Use this to

accept network settings automatically from a

DHCP server enabled so that the

dLAN 200 AVpro Wireless N automatically receives an

address from it.

You can also assign a static IP address by making en-

tries under IP address (e.g. '192.168.0.249') and

Netmask (e.g. 255.255.255.0).

If you ever forget the IP address of your

dLAN 200 AVpro Wireless N, open the

dLAN AVpro manager to find the device in

the network. Proceed as described under 4.1

Calling up the built-in configuration in-

terface.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 76 77

Pas de commentaire

Devolo dLAN 200 AVpro Wireless N Manuel de service Page 34